I have had my tyc one piece projectors for about 3 months now and have noticed since i installed them that they are aimed high so i tires sliding them down and bolting them but they are still high when i installed them i left the metal plates that were in front of the factory lights for holding them in place i guess has anyone had he same experience or do you have any ideas oh how to correct this. If anyone has cutoof pictures that would be nice also.
.my ebay projectors had aiming screws
.one piece projectors and where were the screws just in case im a knuckle head and didnt even realize
.yes i have 1 piece black projector headlights and no they arent tyc
the aiming screws were on the back of the headlights around the projectors themselves
.i've got tyc',s had the same problem, look on the back of the housing, (right behind the actual projector) there should be 2 screws directly at the back. not the ones that stick out, theres 2 little screws that all u gotta do is take a phillips screwdriver to it, and you can adjust the beams. if i had my bumper off i'd take a pic, sry.
.i have to take the bumper off to do all this
.how do you know,at which angle they need to aim? since u don't have the tools they use in the garage...
.park you car 25 feet then aim you headlight so that the focus of the beam is just above the crack of the wall and the ground. make sure that both headlights point in a straight line and not facing into on comming traffic. i made mine face slightly inwards. hope that helps a little
.your drivers side headlight is supposed to face slightly lower and inwards compared to the passengers side |
Post at 2011-5-24 07:47
| This Author's Posts Only
